Search models, users, collections, and posts
Xarilk Gen3 Angle Finder Holder
IP Report
Print Profile(1)
0.16mm layer, 4 walls, 15% infill
Designer
59 min
1 plate
Open in Bambu Studio
Boost
2
2
2
0
3
2
Released
Description
This is a simple angle finder holder, providing a reference plane for an angle finder (like TSProf AxiCube, etc.) on a Xarilk Gen3 guided knife sharpener.
Simply print it (no support is needed!), lightly sand away any bulge and bumps on the plate side, and glue a steel plate for a magnet.
I used 28 mm width steel ruler cut in size.
Additional glue between the holder and the aluminum rod will further enforce the stability.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)