Overture TPU 95A Preset (55mm/s) 0.6mm Nozzle

Overture TPU 95A — 0.6mm Nozzle — Only tested on A1, A1 Mini                                                 

  Most TPU profiles are tuned for slow and safe. This one is tuned for fast and   

  reliable — without sacrificing surface quality.

  Dialed in specifically for Overture 95A with a 0.6mm nozzle. Prints are         

  consistent, surfaces look clean, and it doesn't require babysitting. Good for

  phone cases, cable organizers, flexible hinges, grips, vibration dampeners —    

  anything where you need TPU to actually work.

  Tested on: Bambu A1 only. Results on other Bambu printers may vary — use as a

  starting point and tune from there.

  The model photos show prints made with these exact settings. Those models are   

  not included — this listing is the profile only.

  Before you print: Dry your TPU. Wet filament is the #1 reason TPU prints go     

  wrong — stringing, bubbling, weak layer adhesion. 6-8 hours at 50°C in a food

  dehydrator or filament dryer before printing. If it's been sitting out for more 

  than a few days, dry it regardless.