Cross with the face of Jesus Christ second version

Attention before reading: when removing the supports, cut them at the lower rear part and detach them gently, otherwise you risk breaking a piece of the cross. See image below:

I propose this second version of a magnificent Cross with the face of Christ the redeemer with thorns (this is the second one I've made; for the first version, here is the link: Cross with the face of Jesus Christ - Free 3D print model - MakerWorld ) 

I used a wood filament. Excellent for gifting or as a decoration for Walls, Office Furniture, Home, Church, or places of worship.

The model can be enlarged or reduced as desired by the slicer. Colors can be varied by the slicer.

I put a hole in the back to hang it.

A tip I always give is to first clean the print bed with dish soap and a sponge, rinsing with hot water, then drying it with compressed air, avoiding touching the surface with your hands. I also recommend performing the dynamic flow and flow rate calibrations provided in Bambu Studio. Personally, before printing, I dry the PLA with AMS 2 PRO for about 1 hour. These small precautions, along with many others, determine the success of a good print.

Before leaving negative reviews, please adjust these parameters. If you have difficulties or continue to encounter problems, do not hesitate to contact me; we will find solutions together in a perfect collaborative atmosphere. I have made several prints of this object and they all came out perfect as in the photos: if you have incorrect parameters, dirty or clogged nozzles, poorly calibrated machines, wet or poor quality filaments, do not blame me.

Happy printing everyone!

PRINTING INSTRUCTIONS:

• Layer height 0.2 mm

• Initial layer height 0.2 mm

• Wall loops 2

• Top shell layers 5

• Bottom shell layers 3

• Infill 15%

• Grid pattern

• Supports Yes

• Outer wall speed 200 mm/s

• Inner wall speed 300 mm/s

• Normal print acceleration speed 8000 mm/s

• Outer wall acceleration speed 8000 mm/s