Magnets Holder (magnets 2x1mm)

This device can be used as a magnet holder to easily handle magnets with a 2 mm diameter and 1 mm height, like those required for my 3D HeroQuest tableboard (https://makerworld.com/collections/22024675).  It can be fitted onto a pen (as shown in the picture) with a diameter of 9mm without glue, or comfortably held between your fingers.

To use it, glue a magnet onto the tip with super glue. Once the glue has dried, it will attract the magnets to be inserted into the holes with the correct polarity. If you’re using it for my 3D tableboard, print one for the rooms and a second one for walls and door bases: apply a magnet to the second cap with reverse polarity compared to the one applied to the first cap; if everything is ok, bringing the two magnets close together will make them attract each other.

After a certain number of uses, it may be necessary to remove glue residue that builds up on the tip magnet. To do this, simply rub it lightly with sandpaper!

It's free, so don't forget to rate this model if you like it and….