Search models, users, collections, and posts
Phillips Kitchen Robot Blender Reinforcement Ring
IP Report
Print Profile(1)
0.24mm layer, 3 walls, 25% infill
Designer
35 min
1 plate
Open in Bambu Studio
Boost
0
0
0
0
1
1
Released
Description
We have the Phillips kitchen robot and the blender attachment broke several times ( very bad quality) on the base so I decided to reinforce it with a 3d printed ring. I used 2 component epoxy to glue it down to the base. Keep in mind that the ring fits very tight and if you test fit it to the very bottom is very hard to remove it later, however do not leave it without glue else the acrylic parts might snap off again.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)