GWM Cannon 2025 - Cradle Mount

I designed this cradle to fit snugly between the GWM cannon 2025 - infotainment and cluster display. It has two small tangs that fit behind the displays to help hold it in place with friction as well as a lower broad section with the help of double sided tape to stop it from moving when pulling the uhf mic away from the holder. The holes are positioned to work for the GME MB207 magnetic mic holder but should fit other mic holders. I have printed in PETG but probably would be best to use ASA due to the high heat on the dash area. 

To fit this it’s easiest to lay it on its back with the tangs facing towards you behind the display and slowly rotate the whole body down. It is a tight fit so take care when fitting. Their should be room behind the displays for the tangs but again check your vehicle to make sure you don't damage anything.

## Disclaimer

This 3D model is provided “as-is” with no guarantees of performance, durability, or safety.

By downloading and using this file, you agree that:
- You are responsible for ensuring correct installation and suitability for your specific vehicle.
- This part has not been tested to any automotive safety standards.
- The creator is not liable for any damage to vehicles, equipment, or personal injury resulting from the use or misuse of this design.

Installation should be carried out carefully:
- Do not install near airbags or safety-critical components.
- Ensure the part is securely mounted and does not interfere with vehicle controls or visibility.

Use at your own risk.