Search models, users, collections, and posts
SO-239 female cap (UHF antenna connector)
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 3 walls, 15% infill
Designer
49 min
1 plate
Open in Bambu Studio
Boost
5
12
0
0
21
26
Released
Description
Some changes from the original model from D.Bariov (thanks!) than enhance quality, lower filament usage and faster printing with PETG
- Using PETG and 0.16mm layer height
- Plugged the upper hole to avoid water accumulation
- Add a spherical inside bottom and top to reduce bridging and overhang imperfections
- Changed brimming to Inner for better visual quality (remove after printing)
- Reduce wall loops and infill to lower filament usage and faster printing (should still be strong enough)
73 CT7ABP
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)