Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 8% infill
Designer
11.6 h
1 plate
Open in Bambu Studio
Boost
55
102
1
2
25
11
Released
Description
Thor - Can Holder
- Fits long EU cans with a capacity of 0.5L. You can also use my insert for 12oz or 330ml (slim) cans (link below)
- Recommended print settings: PLA, 0.2mm layers, 2walls, 8%gyroid, brim, Automatic (28°) tree support, It is necessary to set supports even under small overhangs, added supports under the hammer, see picture below.
- Just use my profile :)
Remove the supports wisely, very very!! carefully with pliers, especially around the hammer. It is better to spend 5 minutes removing the supports than to have a ruined piece.
Here is the link to my model of the insert that you can use in 0.5L holders with your 12oz , or 330ml slim cans, and 10mm riser if you want better access to the top. They are scalable, so you can make them smaller or larger in your slicer.
Happy printing:)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)