Minecraft Villager fidget toy (multi-color, no AMS required)

• The version I printed had a long nose, the uploaded model has been fixed to the normal length...
• The eyebrows might be blocked by the overhang of the nose bridge, so I also chamfered the eyebrows to avoid this overhang deformation~

The head, body, eyebrows, whites of the eyes, and pupils - all 5 of these parts can be customized with color~~

My AMS happened to have black, gray, pink, and orange, so I directly used these 4 colors for printing...

A mechanical keyboard switch is needed, I used a domestic switch left over from a previous keyboard keycap replacement...

First, place the switch into the mechanical switch holder. The holder is secured using the switch's own clips, and it has been tested to be very firm~

If you don't have a switch, you can also use the 3D printed switches available on the site~

Then insert the switch holder into the body. No tolerance was left here for a tight fit, just push it all the way in with something~ I used a marker to push it...

Then, directly snap in the eyebrows, pupils, and whites of the eyes. No tolerance was left here either. Because of elephant's foot on the bottom surface, it's easier to install with the bottom facing outwards. You can apply some 5800 glue or similar here for reinforcement;

Then, just insert the head onto the switch. The cross-shaped slot at the bottom of the head where it connects to the switch has a tiny bit of tolerance, so glue is needed to help secure it~ Just a drop will do~

The back is designed with holes so it can be used as a hanging decoration~~

However, because the head is relatively large... hahahahahahaha it's easy to stand upside down~~~