Trident Staff

About

This trident staff is not sharp, and has rounded edges.  It's intended for a cosplay prop or kids toy.

Print Instructions and Assembly

Supports are needed for the trident.  The other models benefit from a brim, and I recommend at least an inner brim.  Using a glue stick may help.

The separate pieces must be glued together, and it's pretty straightforward how it fits together.  Choose either the regular or large trident top piece.

If you use a single middle piece, you'll need to print two inside rods to connect them to the bottom and top piece.  This trident staff is customizable in length, so you can add more middle pieces to lengthen it, but will need an additional inner rod to connect them for each middle piece you add.

This trident staff has pieces that are compatible with some of my other staffs and scepters.  So feel free to check out the ones linked below, and you can mix and match.  For example, the bottom part of the Sunrise Scepter is more of a handle, and could be used in place of this one.

https://makerworld.com/en/models/2241296-sunrise-scepter

https://makerworld.com/en/models/2255280-scepter-of-hearts

Connect with Me

I'm excited to share my 3D designs with the community, and I'd love to see your prints!  If you share them on Instagram, please consider tagging me, so I can celebrate your amazing prints!

Instagram: @OriginalClassicAdam

YouTube: @OriginalClassicAdam

Friendly Reminder and Disclaimer

These models are provided as-is, so please take care when using them and adapt as needed. Please use common sense and caution when printing or assembling.  I cannot make any guarantees about their performance or safety.  By downloading or using these files, you accept responsibility for any outcomes.