Nebuliser stand - Mesh KS015 - 45mm diameter

A relative recently got a new nebuliser.   It's much smaller than his old mains powered one and cordless so much easier to use.   However, it will not stand up on its own, does not come with a stand and leaks if left on it's side.   I designed and printed a simple stand.   It's stable so easy to access without fear of knocking everything over.  It's mostly self centering so the face mask will naturally fall to the front so less likely to be knocked and will not fill with dust. Unfortunately the charge port for this one is on the bottom so could not engineer in a hole to enable it to charge in the stand but it goes weeks between charges so no drama. 

Please leave comments or even a boost if you find this useful or have any suggestions for another version. 

I printed this in blue PETG.  You can print it in pretty much any material as there is no real stress on any part of it.  I used PETG as it's the only filament I have in blue and he wanted a blue stand!   Fits an A1 mini.