"Wobble-Tee" sprinkler mount for wooden stake

The “Wobble-Tee” lawn sprinkler is Australia's best selling commercially sold lawn sprinkler. The water efficient ‘wobble head’ design is great for watering large areas while saving water, especially when multiple sprinklers are used together.  This model allows you to improve the range and usability of this commercially sold sprinkler by raising it up much higher on a wooden stake.

This print design allows you to securely mount a Wobble-Tee sprinkler on top of a 25mmx25mm (1inch x 1inch) wooden garden stake allowing you to greatly increase the range of this commercially sold sprinkler, making them much more efficient. 

Note: this is not a print for the sprinkler itself, you buy that part from the store. Print is a mount for the store bought sprinklers. 

The mount is printed in two halves which are later glued together; the ‘base’ part which attaches to the wooden garden stake, and the ‘pins’ part which secures the sprinkler itself.  Super glue/cyanoacrylate glue is recommended, although most commercial glues designed for plastic should also work fine to join the two parts into the finished part.

Screw the mount to the garden stake using a screw each in the top and on the side, then use a reusable tie*, string, wire, etc to secure the sprinkler to the mount.  

*ps. to secure the sprinkler to the mount in the sample photos I used the following printable reusable tie as follows, printed in TPU they work great (but any regular zip tie, string, wire, etc will also work fine).

https://makerworld.com/en/models/754897-simple-flexible-reusable-gardening-tape-zip-tie#profileId-688998