Shower Stall Water Bottom Sweep

This clips on to the bottom of the shower door to re-direct water coming down the door into the shower stall.  These are pretty easy to buy at your hardware store, but the lip on the bottom is never big enough for our shower stall, so water just drips on the top and some runs inside and some runs outside of the shower.  So this has a very oversized inside lip to ensure water runs into the shower.

I printed this in clear PCTG, which I think worked out fairly well.  The uploaded model is generic PETG which should be fine, it does need to have a bit of flex to hold onto the glass nicely.

Specs:  Glass width 9.3mm, 10.5mm gap under the door.  41mm wide lip.

I need to print two of these for the width of my door.  I was worried it would look bad having two section, but it kind of vanishes to be honest.