Search models, users, collections, and posts
Gridfinity iFixit Mako & Mahi Holder
Remixed by
IP Report
Print Profile(3)
Non Stackable
Designer
7.1 h
2 plates
Stackable
Designer
8.3 h
2 plates
A1 Mini, non-stacking
8.9 h
4 plates
Open in Bambu Studio
Boost
21
70
6
3
61
20
Released
Description
A Gridfinity holder for both the iFixit Mako and Mahi Kits in their boxes. As the boxes are more than 4U wide I made this double holder to safe 1U instead of adding dead space for a single holder.
There are two variants you can print a 9U high stackable design and a non stackable design with an open top.
Required Hardware
- 4 screws M3x5 for joining the halves
The screw size is a parametric parameter in Fusion 360 so you can easily set a different thread if you want to but the length is limited to 5 mm.
There is also a parameter for extra space if the fit is too tight on your printer.
The inherited parameters for the base width etc. should probably not be changed.
Notes
Made with the personal version of Autodesk Fusion 360 therefore non commercial only.
Source files included.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (6)