Search models, users, collections, and posts
Yolink Speaker Hub Wall Mount / Bracket
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
53 min
1 plate
Open in Bambu Studio
Boost
0
1
0
0
3
2
Released
Description
Props given to mikemaat as this is was remix of his “Snap in mount for YoLink temperature sensor" which I modified a bit to hold Yolink Speaker Hub along with negative parts to allow the sounds from the hub to travel through.
Their design also allows the use of two screws for mounting on the wall and/or is flat on the backside to use double sided tape. In my case I used 3M double sided tissue tape in our travel trailer.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)