Rubik's Snake - Free 3D Print Model

Search models, users, collections, and posts

BUY嘉筆記

Toys & Games>Puzzles

IP Report

GIF

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.12mm layer, 2 walls, 15% infill

Designer

1.8 h

1 plate

3.8(33)

A1 Mini 0.12mm layer, 2 walls, 15% infill

2.1 h

1 plate

4.0(2)

Open in Bambu Studio

Boost

120

233

534

326

Released

Description

Content has been automatically translated.

Show original

puzzle snake ONESTEP PRINT

One-time print. No need to separate parts. After printing, carefully rotate to make each joint movable.

Comment & Rating (46)

@SlavaDanilov

Print Profile

0.12mm layer, 2 walls, 15% infill

WORKS

@Julian_zet

Print Profile

0.12mm layer, 2 walls, 15% infill

Okk

@Musa2879

Print Profile

0.12mm layer, 2 walls, 15% infill

Very beautiful

Show original

@dipship

Print Profile

0.12mm layer, 2 walls, 15% infill

not too bad but it's very delicate and keeps falling apart, it's also very stiff but that might be a sure issue

@Mr.X3D

Print Profile

0.12mm layer, 2 walls, 15% infill

Other Issues:Doesn’t really work as intended. The parts are just to loose, and easily comes apart. With the help of some glue I made a ball though 🤷🏼‍♂️

@kdemamkuponky

it broke. connection parts are weak, broke apart, now it cannot be folded back because the connections are too loose

The designer has replied

@user_578818310

this design is a bit loose if it comes off you can try to press it back sorry

Show original

@user_578818310

The new assembly version has been adjusted to be strong and solid It is recommended to try it https://makerworld.com/zh/models/396188#profileId-297492

@perm_fam

Print Profile

0.12mm layer, 2 walls, 15% infill

Model prints fine, but it breaks apart too easily. Good idea, just needs work on the connectors.

The profile uploader has replied

@user_578818310

I apologize for the negative experience. This print-in-place design requires precise tolerances. Especially since everyone's filament properties and settings vary. Typically, the print result will be either too loose or too tight.

Show original

@AJK77

Print Profile

0.12mm layer, 2 walls, 15% infill

Little loose

The profile uploader has replied

@user_578818310

This version has a looser design Perhaps a tighter version will be made later thanks

Show original

@user_578818310

New design upload Maybe you'll want to try the new assembled version https://makerworld.com/zh/models/396188#profileId-297492

@LindaLoo

Print Profile

0.12mm layer, 2 walls, 15% infill

printed well but kept popping apart when being used

@SRPrints

Print Profile

0.12mm layer, 2 walls, 15% infill

Print came out great but the clearances were to small and the entire piece stuck together.

The profile uploader has replied

@user_578818310

You can gradually rotate the components by hand to separate the components. It is recommended to lower the wire flow rate when printing again. Or try this enlarged assembled version. https://makerworld.com/zh/models/393980#profileId-295097