Holy Week mantilla comb

-Technical description for 3D printing of mantilla comb
Model: Ornamental comb in Holy Week style, without a figure of Christ, without upper candles or a crown.
Recommended material: PETG
-Print settings:
•     Infill: 100%
•     Layer height: 0.2 mm for a good balance between detail and strength
•     Supports: Enabled if the comb has scrolls with overhangs
•     Speed: Moderate (40–60 mm/s) to avoid vibrations in thin areas
-Mandatory post-processing:
•     Curvature: After printing, the comb must be slightly curved to fit the contour of the head.
•     Method: Apply controlled heat with a heat gun or hot water (not boiling) for a few seconds, and gently mold with gloves until the desired curvature is achieved.
•     Caution: Do not apply heat directly to thin or decorative areas to avoid deformation.