Search models, users, collections, and posts
This model is created by Image to 3D
Make Your Model
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
23
45
0
0
53
26
Released
Description
A friend at work uses the image of this runner as their profile picture so I took the picture and ran it through the MakerWorld Image to 3D engine to create a 3D statue as a gift to them. Added the base so the statue could stand on its own. Supports are on the plate only - be careful removing them! You may need nippers to make it a bit easier, or could try an interface layer (not tested). Total height is a little over 9cm, but could likely be resized. Post your results if you do that!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)