Search models, users, collections, and posts
Phone Holder for Original Peloton Bike
IP Report
Print Profile(1)
0.12mm layer, 3 walls, 15% infill
Designer
5.1 h
2 plates
Open in Bambu Studio
Boost
2
2
0
0
3
1
Released
Bill of Materials
List other parts
- Wood Screws #2 x 5/8 in x 2:
- Neodymium Magnets 60 x 10 x 3 mm x 2:
- White Silicone x 1:
Description
ONLY WORKS ON THE PELOTON ORIGINAL BIKE (See my other thing for the Bike+)
This is an easy to install phone / tablet holder for the Peloton Bike.
It just snaps into place using super strong neodymium magnets, no tools required.
Post-Printing
What else you need...
Two Wood Screws #2 x 5/8 in
https://www.homedepot.com/p/Everbilt-2-x-5-8-in-Phillips-Flat-Head-Zinc-Plated-Wood-Screw-8-Pack-806791/204587383
Two Neodymium Magnets 60 x 10 x 3 mm
Buy on Amazon https://a.co/d/9JzGqjr
White Silicone
https://www.homedepot.com/p/DAP-Kwik-Seal-Ultra-5-5-oz-White-Advanced-Siliconized-Kitchen-and-Bath-Caulk-18901/206046677
Assemble The Phone Holder
- Spread some white silicone in each of the elongated cavities
- Insert a magnet into each elongated cavity.
- Let the silicone dry for 24 hours
- Partially screw in a wood screw from the bottom to each screw hole until the tip pokes through the other side.
- Align the lip with each screw poking through
- Hold the lip in place while you finish screwing the wood screws all the way in.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)