Search models, users, collections, and posts
Parametric Robot Vacuum Threshold Ramp
IP Report
Print Profile(5)
1cm heigth, 0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Designer
2.1 h
3 plates
2cm heigth, 0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Designer
2 h
3 plates
3cm heigth, 0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Designer
2.5 h
3 plates
1.5cm height, 0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Designer
1.7 h
3 plates
Click to see more
Open in Bambu Studio
Boost
6
55
0
0
44
11
Released
Description
Does your robot vacuum get stuck at the transition between your tile and floor? Is the noise of the Robot getting up and down annoying you?
This is the fix!
I designed this ramp to replace the ugly, worn-out metal threshold strips that block robot vacuums from moving freely between rooms. The gentle slope gives your vacuum a smooth ride over the height difference — no more getting stranded mid-clean and way less noise.
- Fully parametric — create your own ramp
- Rounded ends for a clean, furniture-friendly look
- Minimal, low-profile design that blends into any floor
- No supports needed — prints flat on the build plate
I provided the .f3d File for Fusion360 and also SketchUp (not tested)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)