Tagilla - Escape from Tarkov - ChromaLink

ChromaLink Hex Wallart for Escape from Tarkov Character “Tagilla”, based on the ingame Poster of Killa and Tagilla.

Based on the ChromaLink Base System from the Creator “Superseaslug”

Below are the default Hueforge instructions, add 18 layers to the swap instruction as the ChromaLink base is 18 layers high.

As the print uses more than 4 colors, you need to manually change filaments in the AMS midprint.

For example, black is the first color. After is completes, I just removed it from the AMS and replaced it with white. Make sure you assign the 5th color (which is white) to black instead durig filament selection.

The Model is 217.74x250mm in size

You may print at higher layer heights below the Base Thickness of 0.16mm
The Max allowed Thickness is 1.92mm and the Actual Thickness is 1.92mm

    #080a0d PLA PolyLite Black  Transmission Distance: 0.3
    #545454 PLA BambuLab Basic Dark Gray  Transmission Distance: 0.6
    #9d2235 PLA BambuLab Basic Maroon Red  Transmission Distance: 1.6
    #f99963 PLA BambuLab Matte Mandarin Orange  Transmission Distance: 3
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 5 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Dark Gray
    At layer #12 (1.04mm) swap to Maroon Red
    At layer #13 (1.12mm) swap to Mandarin Orange
    At layer #18 (1.52mm) swap to Jade White for the rest.