Philips Multigroom 5000 7000 9000 extended Stand

Hello! I present you a vertical stand for the Philips Multigroom.

It is based on this one but I couldn't organize all of the attachments so I extended the model to double to amount of compartments.

Features:

• 14 compartments for attachments
• 5 side compartments for blades and other attachments
• 1 base for the main unit

As there are a lot of overhangs the compartments will not look clean, but this should not be a problem unless you want an immaculate look. In that case you might need to lay the part on its back, enable supports and meticulously remove them afterwards.

Print settings:

• 0.4mm nozzle
• 0.2mm layer height, but set to 0.6 variable
• 2 walls
• 10% cubic infill

Please check your filament before printing this model.

Here are my other models: https://makerworld.com/en/@MasterCake