Search models, users, collections, and posts
Graef CM800 portafilter
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
Open in Bambu Studio
Boost
0
1
0
0
2
2
Released
Description
A friend needed a replacement portafilter holder for his Graef CM800 coffee grinder so I designed one similar to the original one for him to use.
It fits portafilters that are 56mm wide on the exterior and fits quite snug so it doesnt move once installed.
I printed it in Matte PLA and so far it feels sturdy enough.
You can check how it compares to the original one in the pictures. The original one is on the left side.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)