Search models, users, collections, and posts
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3.1 h
2 plates
Open in Bambu Studio
Boost
24
49
1
0
19
8
Released
Description
Easy to print and assembly.
This require a disposable camera lens that is approximately 11.9mm in diameter. If needed the edges of the lens can be sanded. I had to sand lens edges little bit to fit the lens adapter. I used the original lens from a Kodak Fun Aqua Sport 35mm Camera (look pictures).
Lens removal from this camera is very easy, just break it and take the lens.
I have taken some part from the original models. M-mount and lens adapter from Technosun, top cookie from SonicPulse and focusring from arvi-arvi.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)