The Lion, the Lamb, and the Cross Bookmark

This is a HueForge printed bookmark.  It requires a 0.2mm nozzle and has a layer height of 0.04, with a base layer height of 0.12.

I used Marswork Black PLA with a TD = 0.1 but I'm sure any black PLA will work fine.

Then at layer 13 switch to a white with a TD of 6.6.  I used Polysonic White.

Recap:

0.2mm nozzle

Layer Height of 0.04

Initial Layer Height is 0.12

Start with Black PLA.

At Layer 13 switch to White with a TD = 6.6 (Polysonic White works very well)

And just to be clear, I've added the description from the HueForge project description file below:

Project: Lion_Lamb_Cross.hfp

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.12mm

The Model is 89.83x134.75mm in size

You may print at higher layer heights below the Base Thickness of 0.52mm
The Max allowed Thickness is 1.24mm and the Actual Thickness is 1.24mm

    #000000 PLA Marswork Black PLA Transmission Distance: 0.1
    #d2ffff PLA Polysonic White Transmission Distance: 6.6
This print uses 2 unique filaments

Swap Instructions:
    Start with Black PLA
    At layer #13 (0.6mm) swap to White for the rest.