Mini 14/30 A-TM Grip

Simple and unique grip for the Samson ATM stock. (Untested on the BTM)

Pictured Model: Shown after some use and removal of hockey tape over the grip. Printed in PETG CF, ALL WALLS, & FUZZY SKIN.

Note: This grip is larger than the factory and sits 15° from vertical. It was designed to my own preferences and grip style.

There is an inset in the grip that allows the factory mounting bolt and nut to be used without modification.

Modifiers are in place to limit the locations of “fuzzy-skin” to ensure proper fit against the stock. If you want to use “fuzzy-skin,” DO NOT remove modifiers.

Strongly recommend printing “all walls” and not using PLA. PETG and PETG CF have proven sufficiently temperature-resistant for this application. 

Install the nut first, with the opening facing upward. Insert the bolt through the stock and into the grip from below without flipping the orientation, then tighten the factory bolt.

This model is not finished, but there have been several requests to upload it, regardless. Enjoy.