Search models, users, collections, and posts
PinkyZup Pz5 Bando Boot
IP Report
Print Profile(2)
Boot no Countersunk Washer 0.2mm layer, 3 walls, 25% infill
Designer
51 min
1 plate
Boot w/ Countersunk Washer 0.2mm layer, 3 walls, 25% infill
Designer
55 min
1 plate
Open in Bambu Studio
Boost
4
0
2
0
9
2
Released
Description
I made up some bando boots for the Pz5 frame from PinkyZup that should protect those motors while you're bashing it :)
PLEASE NOTE THAT THE PICTURE SHOWN IS NOT OF THE BOOT ITSELF, THE VERSION I MADE DOES NOT USE THE RECESSED/COUNTERSUNK WASHERS. I BELIEVE IT IS BETTER TO HAVE THE SCREW HEAD ON BARE CARBON SO YOU CAN FULLY TIGHTEN IT WITHOUT DISTORTING THE TPU. I WILL HAVE TWO VERSIONS, ONE WITH WASHERS AND ONE WITHOUT.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)