Batteria Parkside 10 A/h CASE Battery 5S2P - 21700

Fully 3D printable and perfectly functional Parkside X20 version battery with 10 A/h capacity and 40A continuous discharge. This battery was designed with 5000 mAh - 20 A discharge 21700 cells in a 5S2P configuration, 0.2 mm nickel plates, and a standard X20 BMS purchased on Aliexpress. This battery version is not available commercially and is a powerful and compact version for longer life compared to commercial batteries, as it uses higher-performance cells than the usual 18650s

To coil the spring, you need to create turns (about 10) with 0.7 mm spring wire in the appropriate cylinder attached to the project and then stretch it to the desired version. To restore performance due to the stress of stretching the spring, the spring must be heated to a temperature of about 250 degrees for 30 minutes (do not exceed the temperature because the opposite effect could occur and it might not work)

Depending on the type of BMS they ship you, there is a possibility to extend the protruding capacitor

This Parkside X20 version tool battery consists of:
N.1 Upper part for tool attachment where the release clip is placed and with battery level indicator
N.1 Battery release/attachment clip for the tool
N.1 Bottom base
N.1 Battery/BMS holder
N.1 Spring winder

N.1 Battery level indicator button

Additional necessary materials:
N. 10 21700 cells 5000 mAh 20A discharge
N. 20cm of 0.7 mm spring wire
N.1 Parkside X20 version BMS
N.4 3mm screws with 4mm head approximately 1.5cm long

Fully assembled and perfectly functional battery available for sale