Search models, users, collections, and posts
Cleco Caps
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Open in Bambu Studio
Boost
5
5
0
0
5
1
Released
Description
Cleco Caps for your build to stop scratching the primed surface (where needed).
I printed them from Shore 95A TPU should be sufficient and feasible. The caps have a snug fit on the Cleco. The hole in the bottom is not 1:1 the same size as the Pin to allow for tolerances in the print.
As the only difference between the different types is the hole size, it could also be possible to only print the biggest size and use them on all colors ( it would be great if anyone could confirm that this is usable :) ).
Available in
| Color | Size inches (mm) |
|---|---|
| Silver (zinc) | 3⁄32 (2.4) |
| Copper | 1⁄8 (3.2) |
| Black | 5⁄32 (4.0) |
| Gold (brass) | 3⁄16 (4.8) |
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)