Print Profile(3)
Description
Arrange a 10cm waterwheel for everyone's fish tank. It has an internal filter function. Driven by an air pump. It's fun and looks good, manual installation.
A small amount of filter material needs to be placed inside the box, otherwise it will be too light and float. I put volcanic rock. A small amount of filter floss in the water inlet part. There's a 6mm air tube hole, just insert the air tube and turn on the air pump.
Installation is also simple, no hardware needed. 2 hours printing 45g filament
Latest modification: The waterwheel shaft is now secured with screws. The waterwheel and blades are newly designed, no tolerances were built in for this part, so you'll need to tap them in with a small hammer or scrape out appropriate tolerances with a knife for installation.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)