Search models, users, collections, and posts
Heltec E-213 Vision Master Meshtastic Lora
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
2.7 h
2 plates
Open in Bambu Studio
Boost
17
28
3
0
25
8
Released
Description
Vision Master E213 ESP32-S3R8 LoRa Development Board SX1262 Chip with 2.13" E-Ink Display LoRaWAN BLE 5.0 WiFi Compatible with Arduino LoRa Meshtastic IoT（902-928MHz).
I was looking for a case for the Heltec E-213 Vision Master that was similar to an Alley Cat design, but no luck. So I made a rough copy cat…see what I did there?
- Installation is tight so be careful as you will need to slightly flex the model to allow the device to slip in, especially around the buttons.
- Get the Vison Master here (Amazon)
- Used the Hiteuoms 3.7V 3000 mAh battery (Amazon)
- Remember to attach the antenna before powering on.
UPDATE: Second Plate has an optional component to be used with a Baofeng style belt clip.
- Get the Baofeng Belt Clip here (Amazon)
- Hardware needed is 2x M2.5 x 8mm screws and nuts
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)