Search models, users, collections, and posts
Meticulous Espresso Purge Cup
IP Report
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
0.16mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
2
7
0
0
12
11
Released
Description
I wanted a purge cup that actually looks like it belongs with the Meticulous espresso machine. This design follows the same lines as the brew cylinder housing and includes the logo at the bottom for a clean, OEM-style look.
It’s set up for AMS/multi-color printing, but looks just as good in a single material if you’re running a non-ams setup.
It holds around 170 ml so there's plenty of capacity. The walls are fairly thick, I printed mine in PLA and it should be ok without visible warping on the outside (but time will tell), obviously other filaments are going to withstand the heat even better.
Do not drink the purge, especially when using this cup.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)