Shotgun shell holder with belt/molle/pals support

Finding the right shotgun shells from storage can be a bit of a pain when you have steel, lead, tungsten, slugs, etc. in various pellet size combinations. This clip allows labeling, storing and easy retrieval of shells in five shell clips.

Features

• Compact, five shell holder that easily slips into a pocket

• Easy to snap on and off 12ga shells

• Clips on to a belt, webbing, pocket, paracord or whatever

• A separate loop works in conjunction with the belt clip to weave the holder to a molle/pals webbing

  • Compatible with Malice clips, 25mm double-sided velcro, etc.

• Room for attaching printed labels or tape for marking the clips with the load type and shot size

• Optional snap-on cover to secure the shells further for bumpy rides

• Separate stripped version available without the belt clips and the loop

• NOTE: an empty holder is slightly curved on purpose. It will straighten out when shells are added.

Printing

• PETG filament works well with this, as it is strong, weather resistant, quite resistant to temperature changes and it is bendy and springy.

• Very rigid filaments will likely be a bad option for this clip as well as PLA for lack of durability.

• Four wall loops works fine and no other fancy print settings were used.

• No supports or brim required, but if you have trouble with first layer adhesion, adding a brim may help.

• Shell holding strength/tightness can be adjusted by uniformly scaling the print size slightly up or down.

Belt clip and the loop

Optional clip-on front cover

Minimal version without a loop and a belt clip

Attaching to Pals-webbing with Malice clips