Busch Light Apple Beer Can LED Lamp

Big thanks and shout out to @yoDonnieG for the model creation on this one!

Need a base to snap on the bottom and insert a tea light or the LED lamp kit or RBG puck light into like what's shown here? 

Check out my new bases-

https://makerworld.com/en/collections/10811102-lighted-can-stands 

Check out my other can models via this collection (and follow it for further upcoming models)-

https://makerworld.com/en/collections/3991480

Or check out individual models-

Dr. Pepper- https://makerworld.com/en/models/918203 

Diet Dr. Pepper - https://makerworld.com/en/models/924016

Diet Coke - https://makerworld.com/en/models/926563

Mountain Dew- https://makerworld.com/en/models/932175

Twisted Tea - https://makerworld.com/en/models/945871 

Check out NexNex2024's work if you don't happen to see the design you are looking for (e.g. Coke, Pepsi, Pepsi Max, etc). There's some great designs to see!
Profile Page - https://makerworld.com/en/@NexNex2024

Light up Can Designs Collection - https://makerworld.com/en/collections/4103762 

A big fan of Busch Light Apple? Print yourself out your very own illuminated version to keep on your desk or shelf!  Tons of detail in the outer diameter of the can, so you should be able to read all the lettering.

A few profiles are available (check back if they aren't available yet)- 

1. “No Glue Required”
   1. A combined profile that has the can and lid as one piece. 
   2. This includes all three sizes as separate plates-
      1. Smaller version made to fit the Bambu Labs tea light (KC008) that is quicker to print.
      2. Life-sized version (true to scale of an actual can that can also fit tea light) 
      3. A slightly larger version with a notch in the side to fit the Bambu labs LED Lamp Kit (MH001) puck.
2. “Separate Can and Lid”
   1. Can and Lid print as separate pieces that require glue to join together
   2. Also includes all three sizes noted above

For the “No glue required” profile, the can and lid print as one, but there is support material to remove from the interior of the can.  For the “Separate Can & Lid” profile, the lid is a separate printed piece, but it has an internal lip to make it easy to align on top the can itself.  A small amount of glue should be used to join the two together.