Embossed Twisty Dragon Egg (12 or 20 Slices)

Join Patreon as a free member to catch new releases & free-to-sell models.

Prowl with 1k+ foxes & ~300 authorized sellers in our Skulk!! 🦊

Friendly Reminder: An active commercial license is required to sell prints of my non free-to-sell models.
>> (My partner and I offer many models you can sell for free!) <<

I'm an ADHD husband, father of 5, QA engineer, market vendor, & self-taught designer.

Thank you for backing my family of 7 & honoring the thousands of hours I've poured into this! 🖤

---

[Full credit to abhi3dmad, on Instagram, for the cover gif. I obtained their permission to use their video. Go check them out!]

Support Notes:

• Uses a center cylinder increased stability while printing

Increasing Success (if you run into issues):

• Reduce print speed
• Adjust brim (increase size, reduce distance)
• Increase plate temperature 3-5°
• Use hairspray or glue
• Increase "supcen" (center supporting cylinder) infill to 3–5%
• Increase z-hop to 0.6-0.9mm
• Turn off “Reduce Infill Retraction”

Profile Notes:

• I do not hesitate to report poor/unfair ratings due to issues with hardware, general bed adhesion, or attempting to print multiple on a single plate
• You are rating MY specific profile & my model, not the adherance of your plate or your ability to alter the profile to fit your needs
• I am approachable & genuinely looking to improve. Please, provide feedback/details/pictures

---
If you like & want to support my work, you can always..

• ⚠️ May have sharp or pointed features that could cause discomfort or injury if handled carelessly
• 🧩 May contain small parts and present a choking hazard
• 👶 Not for children under 3 years of age
• 🧠 Recommended for mature users
• 🤕 ToddysTrinkets is not responsible for injuries resulting from use
• 🛑 Use at your own risk