Gaiqiaohu G17 Pencil Case Follower (does not leave the last one)

Gaiqiaohu G17 (non-TTI) stationery case egg holder replacement part The original factory egg holder always leaves the last one This model fixes this defect

There are five models in total, the only difference being the length of the slide catch lever

Correspondingly: Model 1 (original) Huoshe G17, Model 2 (slide catch +0.5mm), Model 3 (slide catch +1mm), Model 4 (slide catch +8mm), Model 5 (slide catch +3.7mm) Gaiqiaohu original

Model 1 is used for Huoshe G17 (but because the spring tension provided by Gaiqiaohu is insufficient, the slide catch does not engage, requiring a spring replacement, this is not Gaiqiaohu's fault)

Model 4, the slide catch lever is lengthened by 8mm, you can shorten it yourself with tools

Model 5, the slide catch lever is lengthened by 3.7mm, Gaiqiaohu original factory height

I currently use Model 1 for my Huoshe 17 without changing the spring, and most slide catches do not engage (I've given up on it)

Note: Use a tool similar to sprue pliers to modify it as shown in the picture. Must be printed with PETG, do not dry fire it, it is prone to breaking

            If you find that the egg loading port is not large enough, it means that the two spring guide pieces that need to be trimmed with sprue pliers are not short enough. Trimming them a bit shorter will allow eggs to be loaded smoothly (The length is approximately 4mm)

Gaiqiaohu, take a look at this!!!