[EisArashi Original] Lever Hand Cannon - Yixing, Nerf Blaster

This uploaded open-source file can be assembled into a complete appearance, but it has no firing function. To unlock full functionality, core parts are required, which can be obtained from my Taobao store: EisArashi Original.

The file configuration uses PETG, and printing speed has been significantly reduced to increase printing success rate. These parameters have been tested and are suitable for most PETG materials. You can also adjust the parameters yourself if needed.

Some parts are large, making them prone to warping during printing. Sometimes this can even bend the build plate. Pay attention to using low shrink rate materials, enclosure printing, or a thickened build plate.

Assembly tutorial is published on Bilibili: 冰岚凌风EisArashi

Copyright registered work, commercial use without authorization is strictly prohibited!

Copyright registered work, commercial use without authorization is strictly prohibited!!

Copyright registered work, commercial use without authorization is strictly prohibited!!!

..................

Hardware required for the main body can be purchased independently. Below is the hardware list content.

Locking Screws:
M3X35 (i.e. diameter 4, length 35) 2 pcs

Cylindrical Pins:
4X30 1 pc
3X30 3 pcs
3X10 2 pcs
2X40 2 pcs
2X20 1 pc
2X10 2 pcs
2X8 4 pcs
2X6 2 pcs

Compression Springs:
0.4X3X10 3 pcs
0.4X3X20 2 pcs
2.0X22X110 1 pc

Clockwork Springs (Coil Springs):
0.1X5X600 2 pcs

Heat Set Inserts:
M3X4X4 33 pcs
M2X3X3.5 22 pcs

Hex Socket Flat Head Screws:
M2X5 22 pcs
M3X8 21 pcs
M3X10 8 pcs
M3X12 10 pcs

Magnets:
10X10X2 2 pcs

Optical Fiber:
1.5X30 (cut length yourself) 4 pcs

Air Cylinder:
32mm(inner diameter)X37mm(outer diameter)X88mm(length)

Inner Barrel:
13mm(inner diameter)X16mm(outer diameter)X250mm(length)

A little Blu Tack
..................
Hardware required for the bearing tube:

Flange Bearings:
3X8X3 9 pcs

Flat Head Self-Tapping Screws
M3x10 9 pcs