Jeep Ducks - WizardDuck
Print Profile(1)
Description
My wife recently got a Jeep Willis, and now she's on the Ducks in the Jeep train…
So I thought I would make a few custom ducks for here. Here is another one. The Wizard duck.
‘You… shall… not…. QUACK!’
I would suggest something a bit more heat resistant than PLA, as these guys sitting on the dash may bake a bit and melt. I print with Bambu PETG-HF.
On the yellow plate, there are 2 ‘nubs’. The larger is the hat one. I its a bit of a tight fit in the hat, but that is so that it holds well. There is not a lot of contact between the head and the hat alone to glue. the smaller nub is a crystal for the center of the glob that goes on the staff.
The hat is printed off the plate a bit, which makes a bit more waste material, but I found that with the subtle bends in the brim of the hat, it's almost impossible to remove the support material if it's just the interface layer. I also tried to get the little yellow crystal to show by printing in a translucent blue, but alas, no go. If anyone gets it to show through, that would be neat to see.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)