XBloom Omni Dripper repair sleeve

I found that my Omni Dripper attachment for my XBloom Studio was drooping: The ?ABS? housing had cracked on the underside next to the magnetic coupling and the filter holder was drooping.  I modelled and printed this sleeve to slot over the part while still fitting in the mechanism.  It is a tight tolerance, I printed it at 0.2mm layer height and 0.42mm layer width in PETG-HF.  The model may need to be scaled up or down by 0.5% to fit neatly depending on your printer.

I did not need to use glue, it fit tightly enough to hold it rigid.   You should also be able to print this in any other material that is at least as rigid as PETG.