Strong Gears DKS_Basic_DukeDoks

After only a few minutes of using the chassis I printed  for mine Porshe GT3 RS, the original gears broke even though I printed them in ABS and lubricated them properly. That's why I decided to make stronger gears that can be adequately attached to the axles.
The biggest change was the small gear that goes to the electric motor itself. I added an M3 insert to this part, which will help the gear to be significantly more stable on the motor shaft itself.
This should also prevent the motor shaft from widening the pinion hole itself due to friction (this happened to me)
YOU ONLY NEED TO PAY ATTENTION TO THE LENGTH OF THE AXLE ON YOUR MOTOR (IT MAY NOT SUIT YOU IF IT IS SHORT)
The gears in the picture are printed in PETG

Thanks to DukeDoks for amazing RC chassis which you can find here:

https://makerworld.com/en/models/1468804-chassis-1-10-adaptable-dks-basic#profileId-1532742

Thanks for Camargo for super fine model of Porsche GT3 RS:

https://makerworld.com/en/models/1290336-porsche-911-992-2-gt3-1-10-scale-model-rc-car#profileId-1320524