Tap to Pay Flower

A tap to pay credit card flower wand.  Use with your chip enabled credit card.

4 Versions:
Single Color Petal Version: This version will have leaves on the stem and the petals of the flower will be one color

Multicolor Petal Version: This version will have leaves on the stem and you can do the petals of the flower in multiple colors (will take longer)
Multicolor Petals, No Leaves Version: This has more of a branch look to it on the stem so they don't break as easy and the petal of the flower will be multiple color (will take longer)

Single Color No, Leaves Version: This has more of a branch look to it on the stem so they don't break as easy and the petal will be a single color

Multiwand Compatible:
The parts of this wand can be interchanged with the parts of other wands I have designed that are also listed as multiwand compatible.

Assembly Instructions:
1. Remove all support material

2. While holding the base of the CC holder (the threaded area), screw the extension into it

3. Screw the grip onto the extension

4. Place the petal/flower onto the CC holder

5. Screw the center into the CC holder (through the petals)

6. Place your CC in the back side of the CC holder
7. Clip the door into the back of the CC holder

8. Enjoy

Warning: Please note, if you print this with silk/shiny filament it's more likely to break.  Please also note this is 3D printed and printed thin to enable the chip to work, you do need to be somewhat careful with it or it will break.

Warning: Please note, using a slicer other than Bamby Handy or Bambu Studio may result in your credit card not fitting as other slicers may or may not change support settings/add supports in other places.

See all my Tap-to-Pay designs here https://makerworld.com/en/collections/20623205-tap-to-pay-designs

Pictures: I love seeing pictures of your final prints from my design (genuinely).  If you are doing cake pops I love seeing the final cake pops also!

Design requests: If you have a design request feel free to send me a message regarding it and if it's something I can do I will give it a try!

Ratings: If you rate less than a 5 star rating please provide detailed reason as to what the issue is and pictures if possible.  I'm always looking to improve designs but can't do so without feedback.  Please make sure the issue isn't related to your specific setup/filament and keep in mind silk filament tends to be weak.

Please boost!! Boosting my designs helps me fund my hobby and keeps the designs coming!  Thank you to all that provide boosts!

Selling: If you would like to sell prints of my designs please please subscribe to my membership.  I think I have the memberships priced affordably for most people and the funds help me continue my hobby and cover filament/maintenance.  Thank you for those who subscribe and don't steal the designs.