Search models, users, collections, and posts
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
3
3
0
0
3
1
Released
Description
When installing a lightbar on the Apple Studio Display you will face two issues:
- The webcam and green LED get covered (making it unusable)
- The microphones on the center top bezel (there are 3) get covered (muffling them and also making them unusable)
This bracket raises the lightbar so the camera, green LED and microphones get cleared!
If you print it upright, no supports are needed.
Very basic design made on Tinkercad, specific for the Xiaomi MJGJD02YL lightbar, but I believe will fit most models.
Feel free to improve it and share it back.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)