Search models, users, collections, and posts
Aukey MagFusion Aura Qi2 Magnetic charger form
IP Report
Print Profile(1)
0.20mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
0
1
0
0
4
0
ReleasedÂ
Description
This is the negative form for AUKEY Magfusion Aura QI2 charger, if you wish to incorporate it into your own design - I had a decent bit of trial and error, so figured the community would like a finished form too :)
Included is the form projected in a square
The charger itself is 60mm, but I made the hole 60,1mm, so depending on your printers tolerances the fit may vary.
I also made routing for the included USB-C cables, so you are able to unplug the cable, whilst the charging puck stays in position
ALSO! The puck is 1,5mm raised from the bottom of the negative - just to ensure connection
No issues in PLA - adaptive smoothing in Studio makes it gorgeous (though you wont notice it) đ¤
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)