Harry Potter Chamber of Secrets Sink Planter/Pen Holder/Bird Feeder

Inspired by Moaning Myrtle's bathroom sink in Harry Potter and the Chamber of Secrets

The original idea was to design it as a pen holder, but then I considered other possible uses shown in the illustrations, such as a vase or bird feeder, which should also work (though the size might need to be scaled up). However, I don't have the means to showcase real-life examples of these uses, so the homepage image is AI-generated based on the model, and the subsequent images showing it as a pen holder are actual photos

Printing and Assembly Instructions:

• Modular Design: To ensure a higher success rate, I have split the model into multiple parts (a single Print in Place version is also provided)
• Supports: It is recommended to use strong tree supports to ensure printing success, as the sink area requires extensive and complex supports. Carefully remove supports afterwards to avoid damaging the pipes
• Assembly: After printing, use AB epoxy resin or 401 super glue for structural bonding. For the faucets, it is recommended to wait until the glue becomes slightly tacky before installing them to ensure they are securely held in place
• Filament Choice: The illustration uses PLA Marble, you can choose according to your preference

• Size: When designed, the size was a bit small, so the provided model has already been scaled up by 20% in Bambu Studio (133 x 133 x 145 mm). You can adjust it according to your personal needs