Search models, users, collections, and posts
AD5X EASY OFF DOOR HINGE FOR ORIGINAL ENCLOSURE
IP Report
GIF
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
29 min
1 plate
Open in Bambu Studio
Boost
28
52
2
0
107
4
Released
Bill of Materials
Bambu Filaments
Select all
Description
When I need to leave the door open to print in PLA and change the finished build plates for a clean one before starting the next print, the door gets in the way a bit. I made an amateurish adaptation in Fusion360 of the hinge available on the Flashforge website so I can easily remove the door completely when needed.
Print using Creality PETG and it is recommended to use at least 4 walls and print the piece horizontally, as in the photos, for better strength.
Recommended Print Parameters
· Filament Usage: Approximately 6g/piece
· Print Time: Approximately 30 minutes
· Recommended Layer Height: 0.2mm
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)