TPU Thule Bike Rack Rubber Replacement Straps

***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***

##  These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##

TPU Thule Bike Rack Rubber Replacement Straps . 

***Use at your own discretion, I am not liable for any incidents these may cause.***

I designed these TPU straps in Tinkercad to replace a few of mine that I lost. Although they dont stretch as well as the oem rubber ones I find they work well as secondary straps. Modeled after the oem strap, they are thinner as the TPU is not as pliable and the thinner design makes the stretching a bit easier.

This is version 1 I made eventually add some of the grippers near the end to help grip them easier as you stretch them.

I recommend only using these as secondary support straps paired with an OEM, just as a precaution. I think they are durable enough though to use on all in a pinch but again use at your discretion. If you trust them with holding your bike fully do so at your own risk.