Print Profile(1)
Description
Hello!
Here is some information about your MAIK LED Name Lamp:
You can individually adjust the size of each letter, but please make sure all letters are the same size. The covers (inlays) are also mirrored again
For printing, I used the following settings: 0.2 mm layer height and 10% infill
The letters are glued. It is best to use an adhesive suitable for PLA. I personally like to use Marley special adhesive, which you can get at a hardware store. Superglue should also work
If you have any questions, just let me know!
And a thank you to Maik
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)