Search models, users, collections, and posts
Mini Desk Lamp Kit Card - 1st Electronics Project
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
37
65
5
0
63
27
Released
Description
Mini Desk Lamp Kit Card: Your 1st Electronics Project!
Build a fully functional mini desk lamp with moveable joints. No special tools necessary! Light up your lamp with a single LED light.
Printed kit card at 0.12mm with support. Break apart the kit card by hand or using scissors/cutting pliers. Bottom portion of lamp slides into base of the lamp, the top portion of lamp slides into the cylindrical hole of the bottom portion, small top joint slides into cylindrical hole of the top portion, lamp shade slides into cylindrical hole of top joint. LED light sits inside light shade, and I used two wires to connect LED to Arduino uno R3 board. Plug negative end of LED into GND and attach positive end to resistor and plug into 5V.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)