Case for BEACON MONITOR from SQ5IXA Krzysztof

Desktop case for the beacon clock by KRAIT-Technologies. 

In the Fusion file, the parameters are responsible for the size of the assembly:

• assemblyWidth
• assemblyHeight
• assemblyDepth

!!! Depending on the filament's shrinkage, the width and height must be minimally adjusted.

Accessories:

• The switch on the right side is a standard rocker switch from Marquart. 
• The low-voltage socket on the back is this one for me. Use the size you usually use.
• For the screw inserts, I used these threaded inserts.
• To mount the circuit board in the case, I replaced the four original 15mm spacers with such spacers with an M3 screw on one side.

Installation:

• Place the assembled circuit board into the case
• Secure the circuit board with the four spacers
• Center the front panel on the circuit board
• Secure the front panel with four M3 screws of approx. 6mm length. The original screws are a bit too long. Shorten them with a saw or use new screws.