Search models, users, collections, and posts
Customizable OBD-II Reader Cap
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
20 min
1 plate
Open in Bambu Studio
Boost
4
9
1
0
37
30
Released
Description
I needed a cap for the OBD-II reader I picked up a while back from Amazon. I found at least three models that didn't fit in three different ways before figuring out that there doesn't seem to be a precise standard for the housing.
This should save you the trouble of trying to find a perfect match by allowing you to just take a few measurements and print.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)